Adam or Ross, (or??)<div dir="auto"><br></div><div dir="auto">FD on site Sunday presumably was because of power blip Ross mentioned re: transfer switch testing. He said they came because they received an alarm call from our FACP at #90. I want to log relevant details so please reply to this list with the following if you know.</div><div dir="auto"><br></div><div dir="auto">1. Who actually spoke to the FD? </div><div dir="auto">2. What was the specific error or alarm code that was sent from the FACP? </div><div dir="auto">3. Did that align with whatever the FD said they got an alert about?</div><div dir="auto">4. What if anything was done or changed 4.a) with the fire pump control panel?</div><div dir="auto">4.b) with the transfer switch or main power switch?</div><div dir="auto">4.c) with the FACP directly?</div><div dir="auto">4.d) other?</div><div dir="auto">5. What was concluded by the fire department? (Or Encore or Everon if engaged?)</div><div dir="auto">6. What next steps were suggested or planned (aside from asking about Transfer Switch testing which Ross has already done)?</div><div dir="auto">7. Was the controller status checked at the time of the FD visit? It should have been, if the alarm related to power. What was the status?</div><div dir="auto">8. Was the status screen in the “firmware updating state” at that time?</div><div dir="auto">9. If so, did anyone follow the posted instructions for resetting it? </div><div dir="auto">9.a. If yes, then we have a new problem which is that it’s already glitched again and it’s only been 3 days.</div><div dir="auto">9.b. If no, then it’s just a human process problem/gap we can address without spending money.</div><div dir="auto"><br></div><div dir="auto"><br></div><div dir="auto"><u>Wednesday Sept 24, 2026 - Current status</u>:</div><div dir="auto"><ul dir="auto"><li>The fire pump controller is in the “firmware updating” state. </li><li> previously gave us a procedure for getting it unstuck from that state, which is posted on the wall above the test instructions. </li><li>Courtney and I didn’t want to do that without knowing if the current state is </li><li>A) an *intentional* result of something one of you or the Fire Department did on Sunday, versus </li><li>B) a new issue since Sunday, vs </li><li>C) a thing that wasn’t noticed on Sunday but may have already been happening and thus potentially (accurately) sending an alarm.</li><li>Either way we may not have pump power redundancy until the controller is restarted, but it would also be good to understand why this is happening </li></ul></div><div dir="auto">Thanks,</div><div dir="auto">~Tara</div><div dir="auto"><br></div><div dir="auto"></div>